Dr.-Ing. Thomas Nitschke-Pagel

Dr.-Ing. Thomas Nitschke-Pagel, born in 1958, completed his studies in general mechanical engineerin...Dr.-Ing. Thomas Nitschke-Pagel, born in 1958, completed his studies in general mechanical engineering at the Comprehensive University of Kassel/Germany. From 1987 to 1991, he worked as a scientific employee at the Materials Technology Institute at the University/ Comprehensive University of Kassel. Since 1992, he has been a scientific employee at the Welding Institute at the Technical University of Bruns - wick where he is the head of the "strength and component behaviour" and "arc welding" departments. He received his PhD at the Welding Institute in 1994.

3 articles

Designing thin sheet joints executed with little heat in a way appropriate for operation

Prof. Dr.-Ing. Alfons Esderts, Dipl-Ing. Christian Wilmes, Dr.-Ing. Driss Bartout, Prof. Dr.-Ing. Rainer Stark, Dr.-Ing. Thomas Nitschke-Pagel, Prof. Dr.-Ing. Prof. h. c. Klaus Dilger

Issue 5 (2014)

Specialist Articles, 305 - 309

Development of a cost-effective seam tracking system for the automated GMA welding of aluminium alloys

Prof. Dr.-Ing. Uwe Reisgen, Dr.-Ing. Lars Stein, Dipl.-Ing. Christoph Geffers, Prof. Dr.-Ing. Prof. h. c. Klaus Dilger, Dr.-Ing. Thomas Nitschke-Pagel, Dipl.-Ing. Hamid Babory

Issue 4 (2011)

Specialist Articles, 240 - 245

Calculation and measurement of residual stresses in aluminium welded joints

Prof. Dr.-Ing. Heidi Cramer, Dipl.-Ing. Anton Lechner, Dr.-Ing. Thomas Nitschke-Pagel, Dipl.-Ing. Hamdollah Eslami-Chalandar, Univ.-Prof. Dr.-Ing. habil. Dimitris Kosteas, Dr.-Ing. Christina Radlbeck

Issue 6 (2007)

Specialist Articles, 342 - 347